Stjarnagloss Glö Hydrophobic Snow Foam 1L

NEW Glö – Protective Snow Foam with Gloss & Beading

Add instant gloss and hydrophobic protection after your contact wash—effortlessly.

What happens when you combine Glatt and Snö?
You get Glö: a protective snow foam that merges the fun of snow foaming with the beading we all crave, all in one simple post-wash step.

Designed to be used after the pre-wash and contact wash stages, Glö is applied just like a traditional snow foam—but instead of watching dirt slide away, you’ll see (and hear) the foam crackle and disperse, leaving paintwork and glass unbelievably glossy and covered in tall, proud water beads.

Rinse, towel dry, and stand back.
The car will be glowing.

Why Choose Glö – Protective Snow Foam?

Gloss & Protection in One Step
Adds a slick, glossy finish and a hydrophobic protective layer without additional sealants or sprays.

Snow Foam Meets Beading
Combines the visual satisfaction of snow foaming with the instant gratification of water repellency.

Efficient & Economical
A single litre of Glö concentrate delivers approximately 20–40 protective layers, meaning you won’t use anywhere near a full lance per car.

Designed for Pressure Washer Use
For best results, apply with a professional snow foam cannon and a pressure washer capable of 130 bar or more.

For maximum cleaning before protection, pair Glö with Snö X Intensive Snow Foam Pre-Wash.

IMPORTANT – Snow Foam Cannon Care

⚠️ You MUST rinse out your snow foam cannon after using Glö.
All hydrophobic or sealant-based snow foams can gum up the gauze and internals of snow foam lances if not flushed properly.

After applying Glö:

• Run at least 1 litre of clean water through the snow foam lance

• Do this every time after use

Failure to flush the lance may result in reduced performance or blockage.
We cannot accept liability for snow foam cannons that fail due to improper cleaning. Replacement gauzes and lance cleaning guides are widely available online.

How to Use Glö

Application
Apply Glö using a professional snow foam cannon with a pressure washer rated at 130 bar or higher.
If using a lower-powered washer, a stronger dilution may be required.

Dilution
Start with 100ml of Glö in a 1-litre lance bottle. Adjust concentration up or down as required.

Coverage
Foam the vehicle evenly, ensuring full coverage.
Do not allow the foam to dry and never apply to hot panels.

Rinse
Allow the foam to dwell briefly, then rinse thoroughly with clean water.

Dry
Towel dry the vehicle to reveal enhanced gloss and strong water beading.

Mixing Guide

1 Litre Bottle

• Use 50–100ml per fill

• Produces 20+ litres of usable snow foam

• Enough for approximately 30–40 car applications