Mk3 Focus Front Wing Vinyl Set

• Supplied as a pair (one for each side)
• Require a small amount of trimming
• Wet install required
• Cut out logos not available for this product
• No logos included

Please Note:

This product requires a wet install. We recommend using our dedicated application fluid, available to order here

Professional install is highly recommended particularly when purchasing with logos cut out as these can be quite tricky for a novice installation

Basic Installation tips:

1. Ensure the panel of the vehicle is clean and free of dirt. Don't forget to clean under rubber seals and wheel arches!
2. The backing paper must be fully removed from the vinyl before applying it to the vehicle. 
3. Lay the decal on a flat surface with the backing paper facing up
4. Carefully peel the backing paper off the vinyl, revealing the adhesive.
5. Completely spray the adhesive side of the vinyl with the application fluid.
6. Spray the panel with application fluid
7. Position the decal, tucking the top under the rubber seal (if applicable) or over the edge of the panel into the engine bay (vehicle specific)
8. Once happy with the positioning, carefully begin to squeegee out the fluid with a dedicated squeegee. Take your time and start gently. There will be excess vinyl hanging over the edge of the wheel arch. This is normal
9. Leave the vinyl to dry out. Drying times will vary depending on temperature. Some light heat with a heat gun or hair dryer will help.
10. Whilst the vinyl is drying, trim off the bottom of the excess vinyl. Follow the curve of the wheel arch with approximately 1 - 2cm of excess.
11. Begin to fold the vinyl under the wheel arch. This requires some patience and maybe a bit of heat to gradually fold it under and stick to the bodywork.
12. If your wing vinyl's have cut out logos, ensure the vinyl is dry before removing the application tape. Carefully peel back the application tape 180 degrees back over itself.